Malbern Trade Windows

Supply Only PVC-u Windows, Doors & Conservatories Throughout the North West of England

Find us on TwitterFind us on Facebook

Working Together

Building strong and loyal professional relationships with local trades people is what's built Malbern into what it is today - Norths West's leading supplier of UPVC Conservatories, Windows, Doors and Double Glazing to the Trade Installer keen DIY'er and construction industry.

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

How to Toe and Heel Correctly

PVC-U doors are heavy, and although the dead weight is supported on the hinge side when it is opened, there is nothing on the lock side to support the weight, and without employing the procedure of toeing and heeling, the door will, sooner or later, 'drop' on the handle side. To stop a door dropping, the glass itself has to be braced diagonally corner to corner by the insertion of plastic packers slipped in the gap between the glass and frame, under the beading. On the hinge side the packers go at the bottom corner, whilst on the lock side, the packers go at the top (opposite) corner.

If you can imagine the back of a normal wooden side gate, you will see three horizontal planks - one top, one middle, and one bottom. These planks are used for the diagonal planks of wood to sit on so as to brace across, and therefore to stop the gate dropping on the lock/handle side.

Toe and Heeling UPVC Doors

So does my door need toeing and heeling?

When a PVC-U door has 'dropped' the first thing people usually notice is that the lock is not working as easily as it did, or will not lock all. The door may also possibly rub on the bottom as it is closed. Closer inspection may reveal that the mitred welds do not line through at the top and the bottom of the lock side of the door to its framework. If this is the case on any door, then the door will need bringing back to square and it will then need 'toeing and heeling' to prevent it from dropping again in the future. If you suspect that your door may have dropped, then the easiest way to check is to measure corner to corner across the diagonals of the door, and verify that the measurements are near enough the same, or to within a couple of mm or so. A quarter of an inch difference in measurements is too much!

The dropping of PVC-U doors is the most common complaint and part of the reason why so many doors drop is failure to follow this procedure properly. To ensure correct and sustained operation of a uPVC door, it is imperative to get the toeing and heeling right the first time.

For detailed technical information, please see our TechDoc.pdf

 

 

 

How to Toe and Heel a door, properly:

  1. The glazing beading must be removed, and the double glazed sealed unit must be in place, and resting on its plastic setting blocks, for correct drainage to work properly before beginning the procedure.
  2. The opening door leaf must be raised on the lock side to the desired height, to square it up again. For one person to do this on their own; open the door slightly, place a small piece of wood on the floor to use as a fulcrum and in line with the door. Next, place a plank under the lock side of the door to push down on with your foot to raise up the side of the door that has dropped. A word of warning: Some doors will rise up and come off of their hinges, and these are harder to 'jack'.
  3. You should notice a gap between the sealed unit and the door, and this is where the packers are inserted to achieve your toeing and heeling correctly to brace across the glass to stop the lock side of the door dropping out of square.